Stump Grinding in Walnut, NC.
Around Walnut 94% of the ground is at a 15% slope or steeper, and only 2% is under 8%. On ground like that the right answer for most stumps is to cut them low and leave them.
We'll reach out within 24 hours to schedule your free on-site estimate. Prefer to talk now? Call (828) 702-7125.
- We confirm the details and book a time
- We walk the site and talk through the slope, soil, and access
- You get a clear, written, line-item scope
Only on the level ground by the house and the drive. Within a mile and a half of Walnut the USDA soil survey maps 94% of the ground at a 15% slope or steeper and 67% at 30% or steeper, with bedrock within 40 inches under 84%, and it labels the three largest soil units moderately eroded. A stump on that ground is holding thin soil that has already lost some of its top layer. We cut it low and leave it. On level ground we grind 6 to 12 inches below grade, or to rock. Stump grinding in Western NC typically runs $75 to $400 per stump.
Eroded soil over rock at 15 to 34 inches
The five largest soil units near Walnut have bedrock between 15 and 34 inches down, and four of them are on 30 to 50 percent slopes. Roots on that ground can be shallow, and they can show on the downhill side where soil has washed. Grinding a stump there leaves loose soil with nothing to hold it. Tate loam on 15 to 30 percent slopes, 5% of the area, is deeper ground where a stump near a yard can be ground. The nearest NOAA station, 5.2 miles off, averages 42 inches of precipitation a year.
The lay of the land around Walnut
Walnut sits in the hills northwest of Marshall off NC-213, named for the Walnut Mountains that rise to the north. It's classic steep Madison County ground — clay over weathered rock, ridgelines and hollows — where a leaning wall or an eroding bank is almost always a water-and-drainage problem before it's a stone problem.
See the full service on our tree & storm cleanup page, and the wider Walnut service area.
USDA soil survey, USGS and NOAA figures for the ground within 1.5 miles of Walnut.
The soils mapped around Walnut.
What the USDA soil survey maps inside a circle of 1.5 miles around Walnut: 48 soil map units over about 4,500 acres. These are the largest, with the slope and water figures behind the work on lots around Walnut.
| Soil map unit | Share of ground | Slope | Drainage class | On the map | What it means |
|---|---|---|---|---|---|
| Evard-Cowee complex, 30 to 50 percent slopes, moderately eroded | 14% | 40% | Well drained | bedrock about 27 in down | Wall / slope work |
| Walnut-Oteen-Mars hill complex, 30 to 50 percent slopes, moderately eroded | 10% | 40% | Well drained | bedrock about 15 in down | Wall / slope work |
| Evard-Cowee complex, 15 to 30 percent slopes, moderately eroded | 8% | 23% | Well drained | bedrock about 27 in down | Wall / slope work |
| Buladean-Chestnut complex, basin, 30 to 50 percent slopes, stony | 6% | 40% | Well drained | bedrock about 31 in down | Wall / slope work |
| Soco-Stecoah complex, basin, 30 to 50 percent slopes, stony | 6% | 40% | Well drained | bedrock about 34 in down | Wall / slope work |
| Tate loam, basin, 15 to 30 percent slopes | 5% | 22.6% | Well drained | no flooding, shallow rock or shallow water on the map | Wall / slope work |
Across the whole circle: 94% of the ground is mapped at a 15% slope or steeper, 1% as moderately well to very poorly drained soil, and 84% with bedrock within about 40 inches. The town point sits in the USGS watershed unit "Big Pine Creek-French Broad River". Nearest NOAA rainfall normal: 42 inches a year (Marshall, 5.2 miles off). Pulled 2026-11-09 from USDA-NRCS Soil Data Access, the USGS hydrography datasets and NOAA 1991–2020 normals. A soil map is not a site test: we confirm your Walnut lot on the free site walk.
What stump grinding costs in Walnut, NC
These are typical Western North Carolina market ranges, not a Maidenhair Landscaping quote. North Carolina construction runs about 12% below the national average, but our mountain terrain — 15–40%+ slopes, weathered bedrock and saprolite, clay, and tight access — pushes most jobs toward the high end of every range. A flat infill lot sits low; a steep escarpment lot sits at or above the top. Your exact price comes from a free on-site estimate.
| Item | Typical WNC range | Notes |
|---|---|---|
| Tree removal (per tree) | $400–$2,000 | small to large; very large or hazard trees $2,000-$4,000+ |
| Emergency / storm removal | $600–$4,000 | tree on a structure or hazard access; insured |
| Stump grinding | $75–$400/stump | ~$3-$5 per inch of diameter |
What drives it: tree height and diameter, lean and proximity to the house or lines, equipment access on a slope, hazard/emergency conditions, and haul-off vs chip-on-site.
Source: published WNC/NC market ranges via angi.com and homeguide.com . Exact pricing on your lot comes from a free on-site estimate — call (828) 702-7125.
How we do it in Walnut.
Look & locate
We check each stump on your Walnut property for size, rock, surface roots and how the machine reaches it.
Grind below grade
The stump and the surface roots that would catch a mower are ground 6–12 inches below grade.
Backfill
The hole is filled with the grindings or with clean soil, your choice.
Rake & finish
We rake the spot level and leave it ready to seed, plant or build on.
Stump Grinding in Walnut: common questions
The stumps on my bank look bad. Can they at least be cut lower?
Can you grind the one stump in my yard without tearing up the bank around it?
Are you local to Walnut, and are you insured?
Stump Grinding near Walnut.
We work Walnut and the towns around it. Same service, local detail for each:
Other services we do in Walnut.
Need stump grinding in Walnut?
Tell us what you're dealing with — we'll walk the lot, read the soil and grade, and put a real number in writing, free.
We'll reach out within 24 hours to schedule your free on-site estimate. Prefer to talk now? Call (828) 702-7125.
- We confirm the details and book a time
- We walk the site and talk through the slope, soil, and access
- You get a clear, written, line-item scope