Driveway Grading in Clyde, NC.
Around Clyde more than half the ground is at a 15% slope or steeper, including eroded clay loam that sheds rain onto a drive.
We'll reach out within 24 hours to schedule your free on-site estimate. Prefer to talk now? Call (828) 702-7125.
- We confirm the details and book a time
- We walk the site and talk through the slope, soil, and access
- You get a clear, written, line-item scope
A ditch that takes the hillside water and a surface that will not carry it. Within a mile and a half of Clyde the USDA soil survey maps 58% of the ground at a 15% slope or steeper, and about a third of the area is Hayesville clay loam labeled eroded. Eroded clay soaks up little, so the slope above a drive sends its rain down to it. We cut and line an uphill ditch, add culverts or turnouts, and rebuild the surface with a cross slope.
Eroded clay loam on 8 to 30 percent slopes
Hayesville clay loam covers 20% of the area near Clyde on 15 to 30 percent slopes and 12% on 8 to 15 percent. A 23 percent grade climbs 23 feet in every 100. A raw clay cut bank beside a drive sheds soil into the ditch with every rain until it is laid back or covered. The median lot is 0.78 acres and 41.8% of lots are an acre or more, so a drive can be long enough to need several places for water to leave. The nearest NOAA station, 4.4 miles off, averages 50 inches of precipitation a year.
Gravel driveway repair and regrading in Clyde
We reopen and stone-line the ditch, reshape the drive, lay fabric where the old stone has sunk into clay, and compact new base and surface stone. Bare banks along the drive get seed and cover. Western NC prices run $0.75 to $2.50 per square foot to regrade an existing drive and $1 to $3 for a full grade with new gravel, with stone at $20 to $45 per ton. Work at a state-maintained road needs an NCDOT encroachment permit.
See the full service on our drainage & grading page, and the wider Clyde service area.
USDA soil survey, USGS and NOAA figures for the ground within 1.5 miles of Clyde.
The soils mapped around Clyde.
What the USDA soil survey maps inside a circle of 1.5 miles around Clyde: 36 soil map units over about 4,500 acres. These are the largest, with the slope and water figures behind the work on lots around Clyde.
| Soil map unit | Share of ground | Slope | Drainage class | On the map | What it means |
|---|---|---|---|---|---|
| Hayesville clay loam, 15 to 30 percent slopes, eroded | 20% | 23% | Well drained | no flooding, shallow rock or shallow water on the map | Wall / slope work |
| Hayesville clay loam, 8 to 15 percent slopes, eroded | 12% | 12% | Well drained | no flooding, shallow rock or shallow water on the map | Surface grade |
| Evard-Cowee complex, 15 to 30 percent slopes | 11% | 22% | Well drained | bedrock about 27 in down | Wall / slope work |
| Fannin loam, 30 to 50 percent slopes, eroded | 7% | 40% | Well drained | no flooding, shallow rock or shallow water on the map | Wall / slope work |
| Udorthents-Urban land complex, 2 to 50 percent slopes | 6% | 25.1% | Somewhat excessively drained | no flooding, shallow rock or shallow water on the map | Wall / slope work |
| Evard-Cowee complex, 30 to 50 percent slopes | 5% | 40% | Well drained | bedrock about 27 in down | Wall / slope work |
Across the whole circle: 58% of the ground is mapped at a 15% slope or steeper, 3% as moderately well to very poorly drained soil, and 22% with bedrock within about 40 inches. The town point sits in the USGS watershed unit "Beaverdam Creek-Pigeon River". Nearest NOAA rainfall normal: 50 inches a year (Waynesville 1 E, 4.4 miles off). Pulled 2026-11-09 from USDA-NRCS Soil Data Access, the USGS hydrography datasets and NOAA 1991–2020 normals. A soil map is not a site test: we confirm your Clyde lot on the free site walk.
What driveway grading costs in Clyde, NC
These are typical Western North Carolina market ranges, not a Maidenhair Landscaping quote. North Carolina construction runs about 12% below the national average, but our mountain terrain — 15–40%+ slopes, weathered bedrock and saprolite, clay, and tight access — pushes most jobs toward the high end of every range. A flat infill lot sits low; a steep escarpment lot sits at or above the top. Your exact price comes from a free on-site estimate.
| Item | Typical WNC range | Notes |
|---|---|---|
| Regrade existing drive | $0.75–$2.50/sq ft | level + reshape; maintenance regrades from ~$0.50 |
| ABC / #57 gravel | $20–$45/ton | ~3-4 tons per 100 sq ft for a 2-3 in. layer |
| Full grade + gravel | $1–$3/sq ft | new cut, crown/culvert, stone |
What drives it: length on grade, slope, culverts/crossings, crown vs in-slope, stone depth, and NCDOT encroachment if tying to a state road.
Source: published WNC/NC market ranges via homewyse.com and homeguide.com . Exact pricing on your lot comes from a free on-site estimate — call (828) 702-7125.
How we do it in Clyde.
Walk the drive
We look at where water runs on your Clyde driveway, where it washes, and what the base is made of.
Shape & drain
Crown or cross-slope the surface, cut the ditch, and set culverts or turnouts where water gathers.
Stone & compact
The right gravel at the right depth, compacted in lifts so it locks together.
Check the flow
We confirm water leaves the drive where it should, then clean up.
Driveway Grading in Clyde: common questions
My ditch fills with mud after every rain. How do I stop it?
Do you regrade long driveways on larger Clyde lots?
Are you local to Clyde, and are you insured?
Driveway Grading near Clyde.
We work Clyde and the towns around it. Same service, local detail for each:
Other services we do in Clyde.
Need driveway grading in Clyde?
Tell us what you're dealing with — we'll walk the lot, read the soil and grade, and put a real number in writing, free.
We'll reach out within 24 hours to schedule your free on-site estimate. Prefer to talk now? Call (828) 702-7125.
- We confirm the details and book a time
- We walk the site and talk through the slope, soil, and access
- You get a clear, written, line-item scope